Sunlife

The following specifications should be used in for the proper application of the SUNLIFE Roofing System™. Failure to properly follow the specifications will jeopardize the quality of the installation leading to warranty problems in the future. Shortcuts to save labor time now will cost you warranty time, materials, and labor later.

FULL CLOTH SPECIFICATIONS

1. Clean roof thoroughly with pressure wash 1500 psi.

2. Roof must be completely dry and free of visible defects such as cracks, blisters, opened seams and similar defects.

3. On mechanically-fastened single ply roofs, repair all loose screw fasteners utilizing standards set forth in the roofing industry.

4. Repair all defects found with SUNLIFE Roofing Compound™ (SRC 1-gray) and 6" cloth, as follows:

a. Apply base coat of SRC 1-gray at a rate of one (1) gallon per square (8 mils dry film thickness) to the length of defective area.

b. Embed 6" cloth along length of defective area.

c. Apply second coat of SRC 1-gray to top of cloth at a rate of one (1) gallon per square (8 mils dry film thickness).

5. Allow all repaired areas to dry until they are thoroughly dry.

6. Apply a base coat of SRC 1-gray to entire roof surface at the rate of 1.50 gallons per square (16 mils dry film thickness).

7. Lay 40" cloth into wet base coat, lightly brooming to prevent wrinkling. Overlap each roll along lap lines on cloth.

8. Apply first coat of SRC 1-gray to top surface of cloth. Take care to apply product under laps where cloth rolls meet. Apply at a rate of two (2) gallons per square (16 mils dry film thickness).

9. Allow to dry.

10. Apply top coat of SRC 2-white to entire surface at a rate of two (2) gallons per square (16 mils dry film thickness).

This site is best viewed with Netscape Navigator 4.7 or Microsoft Explorer 4.5

Sunlife Systems International, Inc.
5301 Nations Crossing Road
Charlotte, NC 28217
(800) 328-5885
Tel: (704) 527-2480
Fax: (704) 527-0534

Do not duplicate or redistribute in any form.