The following specifications should be used in for the proper application of the SUNLIFE Roofing SystemTM. Failure to properly follow the specifications will jeopardize the quality of the installation leading to warranty problems in the future. Shortcuts to save labor time now will cost you warranty time, materials, and labor later.

1. Clean the area thoroughly. Remove all loose gravel and debris.


2. Repair all visible defects, splits, blisters, etc., utilizing standards set forth by the roofing industry.


3. Apply liberal coat Elastic Roof Sealer at a rate of 10 - 13 gallons per square or so, to allow squeegied material to flow easily over the tops of embedded rock, (200 - 250 mils theoretical film build).


4. Embed flexible mat into wet material, lightly brooming to insure proper lamination. NOTE: Some wrinkling may occur when the material is lightly broomed; however, this poses no problems to the waterproofing characteristics of the system.


5. Apply first coat SUNLIFE Roofing Compound at a rate of two (2) gallons per square, (theoretical film build, 24 mils).


6. Apply second coat SUNLIFE Roofing Compound at a rate of two (2) gallons per square, (theoretical film build, 24 mils).


7. All flashings and counter flashings to receive a base coat SUNLIFE Roofing Compound, flexible mat and two (2) coats SUNLIFE Roofing Compound to a total film of 80 mils.

|Built-up| |Metal| |Singleply| |Universal| |Wet| |US Applicators| |Warranty|

This site is best viewed with Netscape Navigator 4.7 or Microsoft Explorer 4.5

  Sunlife Systems International, Inc.
5301 Nations Crossing Road
Charlotte, NC 28217
(800) 328-5885
Tel: (704) 527-2480
Fax: (704) 527-0534

© 2006 Sunlife Systems International, Inc.

All rights reserved.

Do not duplicate or redistribute in any form.